Maximum-Paths; Passive-Interface - Dell Force10 S4810P Reference Manual

Version 7.8.1.0
Version 7.4.1.0

maximum-paths

Enable the software to forward packets over multiple paths.
C-Series, E-Series, and S-Series
Syntax maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths command.
Parameters
number
Defaults 8
Command Modes ROUTER OSPF
Command History
Version 9.1.(0.0)
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1

passive-interface

Disable (suppress) sending routing updates on an interface.
C-Series, E-Series, Z-Series, S4810
Syntax passive—interface interface
To enable sending routing updates on an interface, use the no passive-interface interface.
Parameters
interface
1224
Added support for the C-Series.
Introduced on the E-Series.
Specify the number of paths. The range is 1 to 64. The default is 8
paths.
Introduced.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the following keywords and slot/port or number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.