Redistribute Ospf - Dell Force10 S4810P Reference Manual

route-map
name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Version 7.4.1.0

redistribute ospf

Redistribute OSPFv3 routes into BGP.
E-Series
Syntax redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id
command.
Parameters
process-id
match external {1
| 2}
match internal
route-map
name
• internal (default)
map-
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny (to drop all
routes).
Introduced on the E-Series ExaScale.
Introduced
Enter the number of the OSPFv3 process. The range is 1 to 65535.
(OPTIONAL) Enter the keywords match external to redistribute
OSPF external routes. You can specify 1 or 2 to redistribute those
routes only.
(OPTIONAL) Enter the keywords match internal to redistribute
OSPFv3 internal routes only.
map-
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
523