Dell Force10 S4810P Reference Manual page 1195

link-state-id
adv-router
address
Command Modes
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage The following describes the show ip ospf process-id database summary
Information
command shown in the Example below.
Item
LS Age
Options
LS Type
Link State ID
Advertising Router
LS Seq Number
Checksum
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID
value depends on the LSA type, and it can be one of the following:
•
•
•
ip-
(OPTIONAL) Enter the keywords adv-router followed by the IP
address of an Advertising Router to display only the LSA information
about that router.
• EXEC
• EXEC Privilege
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the LSA age.
Displays the optional capabilities available on router. The following
options can be found in this item:
•
•
•
Displays the LSA type.
Displays the Link State ID.
Identifies the router ID of the LSA's originating router.
Displays the link state sequence number. This number allows you to
identify old or duplicate LSAs.
Displays the Fletcher checksum of an LSA's complete contents.
the network's IP address for Type 3 LSAs or Type 5 LSAs
the router's OSPF router ID for Type 1 LSAs or Type 4 LSAs
the default destination (0.0.0.0) for Type 5 LSAs
TOS-capability or No TOS-capability is displayed depending
on whether the router can support Type of Service.
DC or No DC is displayed depending on whether the
originating router can support OSPF over demand circuits.
E or No E is displayed on whether the originating router can
accept AS External LSAs.
1195