Redistribute Isis - Dell Force10 S4810P Reference Manual

static
route-map
name
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 7.4.1.0
Usage
If you do not configure the default-metric command in addition to the redistribute
Information
command, or there is no route map to set the metric, the metric for redistributed static and
connected is "0".
To redistribute the default route (0::0/0), configure the neighbor default-originate
command.
Related neighbor default-originate
Commands

redistribute isis

Redistribute IS-IS routes into BGP.
E-Series
Syntax redistribute isis [level-1 | level-1-2 | level-2] [metric
metric-value | metric-type {external | internal}] [route-map
map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
level-1 | level-1-2
| level-2]
metric
metric-type
522
Enter the keyword static to redistribute manually configured
routes. These routes are treated as incomplete routes.
map- (OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Introduced
– injects the default route.
(OPTIONAL) Enter the type (level) of routes to redistribute.
(OPTIONAL) Assign metric to an interface for use with IPv6
information.
(OPTIONAL) The external link type associated with the default route
advertised into a routing domain. You must specify one of the
following:
•
external