Management Route - Dell Force10 S4810P Reference Manual

Command History
Version 9.0.0.0
Version 8.3.11.4

management route

Configure a static route that points to the Management interface or a forwarding router.
C-Series, E-Series, Z-Series, S4810
Syntax management route {{ip-address mask | {ipv6-address prefix-
length}} {forwarding-router-address | managementethernet}
To remove a static route, use the no management route{{ip-address mask |
{ipv6-address prefix-length}}{forwarding-router-address |
managementethernet} command.
Parameters
ip-address mask
ipv6-address
prefix-length
forwarding-
router-address
managementethe
rnet
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.0.0.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage When a static route (or a protocol route) overlaps with Management static route, the static
Information route (or a protocol route) is preferred over the Management Static route. Also, Management
868
Added support for IPv6.
Introduced on the Z9000.
Enter an IP address (dotted decimal format) and mask (/prefix format)
of the destination subnet.
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of
the destination subnet. Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format.
The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Introduced on the Z9000 and added support for IPv6.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series.