Interface Range - Dell Force10 S4810P Reference Manual

Related
interface
Commands
interface loopback
interface port-channel
interface vlan
ip unreachables
unreachable messages.

interface range

This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk
configuration). Using the interface range command, you can enter identical commands for a range of interface.
C-Series, E-Series, S-Series, Z-Series
Syntax interface range interface, interface,...
Parameters
interface,
interface,...
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.5.1.0
– configures a physical interface.
– configures a Loopback interface.
– configures a port channel.
– configures a VLAN.
– enables generation of internet control message protocol (ICMP)
Enter the keywords interface range and one of the interfaces
— slot/port, port-channel, or VLAN number. Select the range of
interfaces for bulk configuration. You can enter up to six comma-
separated ranges. Spaces are not required between the commas.
Comma-separated ranges can include VLANs, port-channels, and
physical interfaces.
Slot/Port information must contain a space before and after the dash.
For example, interface range gigabitethernet 0/1 -
5 is valid; interface range gigabitethernet 0/1-5 is
not valid.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number
from 1 to 4094.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
771