Ipv6 Multicast-Limit; Ipv6 Multicast-Routing - Dell Force10 S4810P Reference Manual

Usage Use the debug ipv6 mld_host command to debug the MLD protocol for all ports or for
Information specified ports. Displayed information includes when a query is received, when a report is
sent, when a mcast joins or leaves a group, and some reasons why a MLD query is rejected.

ipv6 multicast-limit

Limit the number of multicast entries on the system.
E-Series
Syntax ipv6 multicast-limit limit
Parameters
limit
Defaults 15000 routes
Command Modes CONFIGURATION
Command History
Version 8.3.1.0
Usage The maximum number of multicast entries allowed on each line card is determined by the CAM
Information profile. Multicast routes are stored in the IN-V6-McastFib CAM region, which has a fixed
number of entries. Any limit configured using the CLI is superseded by this hardware limit. The
opposite is also true; the CAM might not be exhausted at the time the CLI-configured route limit
is reached.

ipv6 multicast-routing

Enable IPv6 multicast forwarding.
E-Series
Syntax ipv6 multicast-routing
To disable multicast forwarding, use the no ipv6 multicast-routing command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
E-Series legacy
command
Related ipv6 pim sparse-mode
Commands
1128
Enter the desired maximum number of multicast entries on the
system. The range is 1 to 50000. The default is 15000.
Introduced.
– enables IPv6 PIM sparse mode on the interface.