Ip Msdp Originator-Id - Dell Force10 S4810P Reference Manual

Ftos command line reference guide for the s4810 system ftos 9.1.(0.0)

Hide thumbs Also See for Force10 S4810P:

Table of Contents

ip msdp originator-id

Configure the MSDP Originator ID.

E-Series, Z-Series, S4810

ip msdp originator-id {interface}

To remove the originator-id, use the no ip msdp originator-id {interface}

Not configured.

Command Modes

CONFIGURATION

Command History

Version 8.3.11.1

Version 8.3.7.0

Version 8.5.1.0

Version 6.2.1.1

Enter the following keywords and slot/port or number information:

For a Fast Ethernet interface, enter the keyword

FastEthernet followed by the slot/ port information.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet followed by the slot/port information.

For a Loopback interface, enter the keyword loopback

followed by a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel followed by a number. For the E-Series, the range

is 1 to 255 for TeraScale and 1 to 512 for ExaScale.

For a SONET interface, enter the keyword sonet followed by

the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet followed by the slot/port

information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE followed by the slot/port information.

For a VLAN, enter the keyword vlan followed by a number

from 1 to 4094.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.