timers bgp
Adjust the BGP Keep Alive and Hold Time timers.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
timers bgp keepalive holdtime
To return to the default, use the no timers bgp command.
Parameters
keepalive
holdtime
Defaults
none
Command Modes
EXEC Privilege
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.6.1.0
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the Internet and
connecting multicast topologies between BGP and autonomous systems (ASs).
FTOS MBGP is implemented as per IETF RFC 1858.
BGPv4 is supported in the following:
FTOS Version
Platform Support
7.8.1.0, MBGP for IPv6 TeraScale and C-Series
7.8.1.0, MBGP for IPv4
S-Series
Multicast Only
8.2.1.0, MBGP
E-Series ExaScale
Enter a number for the time interval, in seconds, between keepalive
messages sent to the neighbor routers. The range is 1 to 65535. The
default is 60 seconds.
Enter a number for the time interval, in seconds, between the last
keepalive message and declaring the router dead. The range is 3 to
65535. The default is 180 seconds.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
439