Neighbor X:x:x::x Password - Dell Force10 S4810P Reference Manual

peer-group-name
maximum
threshold
warning-only
Defaults threshold = 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Version 7.4.1.0
Usage If you configure the neighbor maximum-prefix command and the neighbor receives
Information more prefixes than allowed by the neighbor maximum-prefix command configuration,
the neighbor goes down and the show ip bgp summary command displays (
State/PfxRcd column for that neighbor. The neighbor remains down until you enter the clear
ip bgp command for the neighbor or the peer group to which the neighbor belongs or you
enter the neighbor shutdown and neighbor no shutdown commands.
Related show ip bgp summary
Commands

neighbor X:X:X::X password

Enable TCP MD5 Authentication for an IPv6 BGP peer session.
C-Series, E-Series
Syntax neighbor x:x:x::x password {7 <encrypt-pass>|<clear-pass>
To return to the default setting, use the no neighbor x:x:x::x password command.
Parameters
encrypt-pass
clear-pass
Defaults Disabled.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0
Enter the name of the peer group.
Enter a number as the maximum number of prefixes allowed for this
BGP router. The range is 1 to 4294967295.
(OPTIONAL) Enter a number to be used as a percentage of the
maximum value. When the number of prefixes reaches this
percentage of the maximum value, the E-Series software sends a
message. The range is 1 to 100 percent. The default is 75.
(OPTIONAL) Enter the keywords warning-only to set the router to
send a log message when the maximum value is reached. If you do
not set this parameter, the router stops peering when the maximum
number of prefixes is reached.
Introduced on the E-Series ExaScale.
Introduced
– displays the current BGP configuration.
Enter the encrypted password.
Enter the clear text password.
Introduced
prfxd ) in the
509