Dell Force10 S4810P Reference Manual page 1253

Usage The following describes the show ip pim snooping tib commands shown in the
Information Example below.
Field
(S, G)
uptime
expires
RP
flags
Incoming interface
RPF neighbor
Outgoing interface
list:
Example
FTOS#show ip pim snooping tib
PIM Multicast Snooping Table
Flags: J/P - (*,G) Join/Prune, j/p - (S,G) Join/Prune
Timers: Uptime/Expires
* : Inherited port
(*, 225.1.2.1), uptime 00:00:01, expires 00:02:59, RP
165.87.70.1, flags: J
FTOS#show ip pim snooping tib vlan 2 225.1.2.1 165.87.1.7
Description
Displays the entry in the PIM multicast snooping database.
Displays the amount of time the entry has been in the PIM multicast
route table.
Displays the amount of time until the entry expires and is removed
from the database.
Displays the IP address of the RP/source for this entry.
List the flags to define the entries:
•
•
•
•
•
•
•
•
•
Displays the reverse path forwarding (RPF) interface towards the RP/
source.
Displays the next hop from this interface towards the RP/source.
Lists the interfaces that meet one of the following criteria:
•
•
•
SGR-P - (S,G,R) Prune
Incoming interface: Vlan 2, RPF neighbor 0.0.0.0
Outgoing interface list:
GigabitEthernet 4/11 RPF 165.87.32.2 00:00:01/00:02:59
GigabitEthernet 4/13 Upstream Port
S = PIM Sparse Mode
C = directly connected
L = local to the multicast group
P = route was pruned
R = the forwarding entry is pointing toward the RP
F = FTOS is registering this entry for a multicast source
T = packets were received via Shortest Tree Path
J = first packet from the last hop router is received and the
entry is ready to switch to SPT
K=acknowledge pending state
a directly connect member of the Group
statically configured member of the Group
received a (*,G) Join message
-/-
1253