Show Protocol-Termination-Table - Dell Force10 S4810P Reference Manual

show protocol-termination-table

Display the IP packet termination table (IPPTT).
E-Series
Syntax show protocol-termination-table linecard number port-set port-
pipe-number
Parameters
linecard
port-set
pipe-number
Defaults none
Command Modes
Command History
Version 8.1.1.2
Version 8.1.1.0
Version 6.4.1.0
Usage The IPPTT table is used for looking up forwarding information for IP control traffic destined to
Information the router. For the listed control traffic types, IPPTT contains the information for the following:
Example
FTOS#show protocol-termination-table linecard 2 port-set 0
Index Protocol Src-Port Dst-Port Queue DP Blk-Hole VlanCPU
EgPort
---------------------------------
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
896
number
Enter the keyword linecard followed by slot number of the line
card. For the E-Series, the range is 0 to 13 on a E1200/1200i, 0 to 6 on a
E600/E600i, and 0 to 5 on a E300.
port-
Enter the keywords port-set followed by the line card's Port-Pipe
number. The range is 0 to 1.
• EXEC
• EXEC Privilege
Introduced on the E-Series ExaScale E600i.
Introduced on the E-Series ExaScale.
Introduced
• Which CPU to send the traffic (CP, RP1, or RP2)
• What QoS parameters to set
ICMP any
UDP any
UDP any
UDP any
TCP any
TCP 22
TCP 639
TCP any
TCP 646
TCP any
UDP 646
UDP any
TCP 23
TCP any
UDP any
TCP any
TCP any
-- -------- --------------
any Q0 0
1812 Q7 6
68 Q7 6
67 Q7 6
22 Q7 6
any Q7 6
any Q7 6
639 Q7 6
any Q7 6
646 Q7 6
any Q7 6
646 Q7 6
any Q7 6
23 Q7 6
123 Q7 6
21 Q7 6
20 Q7 6
No - CP
No - CP
No - CP
No - CP
No - CP
No - CP
No - RP2
No - RP2
No - RP1
No - RP1
No - RP1
No - RP1
No - CP
No - CP
No - CP
No - CP
No - CP