E3-2:Reg Jam - Oki B6100 Technical Manual

There is a paper jam at the Regi position.
Step
1
INITIAL ANALYSIS
Inspect the following components.
• Sensor Photo:Regi (PL5.1.12)
• Actuator Regi (PL5.1.10)
• PWBA Conn (PL10.1.11)
• PWBA HKB26 MCU (PL10.1.13)
• PWBA HKB PS (PL10.1.17)
• Gear Assy Drive (PL8.1.13)
Are they compatible with your printer version, correctly
installed, not damaged, deformed, or contaminated?
2
Is the paper that is loaded in the paper tray wrinkled or
damaged?
3
Is there a sheet of paper at the Actuator Regi when the E3
code appears?
4
SENSOR PHOTO REGI (PL5.1.12) ANALYSIS
1. Use SENSOR/ SWITCH CHECK to check the Sensor
Photo: Regi.
2. Use a sheet of paper to actuate the sensor.
Does the Sensor Regi function correctly and increment
the Sensor Check number on the screen each time you
actuate it?
5
HARNESS ASSY REGI (J43-J431, J432) (PL5.1.28) ANALY-
SIS
1. Disconnect the Harness Assy Regi (J43-J431, J432) from
the PWBA Conn (PL10.1.11).
2. Check the continuity between J43-3 <=> J432-3, J43-4 <=>
J432-2 and J43-5 <=> J432-1.
Is there the continuity between J43-3 <=> J423-3, J43-4
<=> J432-2 and J43-5 <=> J432-1?
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0
Actions and Questions
Primary FIPs:Error Codes

3.10 E3-2:REG JAM

Yes No
Go to step 2. Replace the
problem com-
ponents.
Replace with Go to step 3.
fresh, dry
paper.
Remove the Go to step 4.
jammed
paper.
Go to step 5. Replace the
Sensor Photo:
Regi
(RRP5.1.5).
Go to step 6. Replace the
Harness Assy
Regi (J43-
J431, J432).
3-23