Oki B6100 Technical Manual page 42

Primary FIPs:Error Codes
3.9 E3-1:REG JAM continued
Step
11
DRUM SHUTTER of the CRU (PL8.1.1) ANALYSIS
Does the Drum Shutter open when you install the CRU?
12
BTR ASSY (PL6.1.2) ANALYSIS
1. Remove the CRU, so you can inspect the BTR Assy.
2. Check the rotation of the BTR Assy.
Does the BTR Assy rotate smoothly?
13
BTR CHUTE ASSY (PL6.1.1) ANALYSIS
Inspect the BTR Chute Assy.
Is the BTR Chute Assy clean and free of contamination?
14
HEAT & PRESSURE ROLL of the FUSER ASSY (PL6.1.7)
ANALYSIS
Check the rotation of the Heat and Pressure Rolls using MAIN
MOTOR TEST.
Are the Heat and Pressure Rolls rotating normally?
15
DECURL ROLL of the FUSER ASSY (PL6.1.7) ANALYSIS
1. Open the Cover Rear (PL1.2.5) and cheat the Switch Assy I/
L Rear (PL10.1.7).
2. Execute a test print to check the Decurl Roll.
Does the paper pass through the Decurl Roll without prob-
lems?
16
ACTUATOR EXIT of the Fuser Assy (PL6.1.7) ANALYSIS
Does the Exit Actuator move smoothly when a sheet of
paper strikes it?
17
SENSOR EXIT of the Fuser Assy (PL6.1.7) ANALYSIS
Check the Sensor Exit function using SENSOR/SWITCH
CHECK.
Does the Sensor Exit function correctly and increment the
Sensor Check number on the screen each time you actu-
ate it?
3-22
Actions and Questions
OKI B6100 Laser Printer - Base Engine Technical Manual
Yes No
Go to step 12. Replace the
CRU
(PL8.1.1).
Go to step 13. Replace the
BTR Assy
(RRP6.1.1).
Clean or Go to step 14.
replace the
BTR Assy
(RRP6.1.1) or
Chute Assy
Trans
(RRP6.1.2).
Go to step 15. Replace the
Fuser Assy
(RRP6.1.3).
Go to step 16 Replace the
Fuser Assy
(RRP6.1.3)
Go to step 17. Replace the
Fuser Assy
(RRP6.1.3).
Replace the Replace the
PWBA HKB26 Fuser Assy
MCU (RRP6.1.3).
(RRP10.1.7).
Version 1.0