E4-3:Exit Jam - Oki B6100 Technical Manual

Primary FIPs:Error Codes

3.8 E4-3:Exit JAM

There is a paper jam between the sensor Photo Regi and the Sensor Photo Exit.
Step
1
INITIAL ANALYSIS
Inspect the following components.
• PWBA HKB26 MCU (PL10.1.13)
• P/H Assy (PL5.1.4)
• Switch Size on the PWBA Feeder (PL3.1.36)
• Fuser Assy (PL6.1.7)
• PWBA LVPS (PL10.1.17)
• Motor Assy Exit (PL7.1.21)
• Actuator Full Stack (PL7.1.2)
• Sensor Photo:Exit (PL7.1.17)
Are they compatible with your printer version, correctly
installed, not damaged, deformed, or contaminated?
2
Does the error code appear immediately after you switch
ON Main Power?
3
Is there paper jammed at the Sensor Exit in the Fuser
Assy (PL6.1.7)?
4
DECURL ROLL of the FUSER ASSY (PL6.1.7) ANALYSIS
Check the rotation of Decurl Roll using MAIN MOTOR TEST.
Remove the CRU (PL8.1.1) and inspect the Decurl Roll opera-
tion.
Does the Decurl Roll rotate smoothly?
5
DECURL ROLL of the FUSER ASSY (PL6.1.7) ANALYSIS
Open the Cover Rear (PL1.2.5) and cheat the interlock switch.
Generate a test print to check the Decurl Roll.
Does the paper pass through the Decurl Roll without prob-
lems?
3-18
Actions and Questions
OKI B6100 Laser Printer - Base Engine Technical Manual
Yes No
Go to step 2. Replace the
problem com-
ponents.
Go to step 3. Go to step 4.
Remove the Go to step 7.
paper.
Go to step 5. Replace the
Fuser Assy
(RRP6.1.3).
Go to step 6. Replace the
Fuser Assy
(RRP6.1.3).
Version 1.0