Oki B6100 Technical Manual page 39

Step
6
SENSOR EXIT in the FUSER ASSY (PL6.1.7) ANALYSIS
1. Check the Sensor Exit in the Fuser Assy using SENSOR/
SWITCH CHECH.
2. Manually feed a sheet of paper into the Fuser Assy, then
remove the sheet of paper.
Does the Exit Actuator move freely and without binding
and does the Sensor Exit function correctly and increment
the Sensor Check number on the screen each time you
actuate the
7
ROLL ASSY MID 1, MID 2 and MID3 (PL7.1.7 and PL7.1.11)
ANALYSIS
Check the operation of the Roll Assis MID.
Does the Roll Assis MID function normally?
8
MOTOR ASSY EXIT (PL7.1.21) ANALYSIS
Check the voltage between P/J32-1 and frame ground.
Is there +24VDC between P/J32-1 and frame ground?
9
ACTUATOR FULL STACK (PL7.1.2) ANALYSIS
Fill the Exit Tray with paper.
Does the paper lift the Actuator Full Stack, and does the
Actuator expose the photo-sensing point of the Sensor
Photo:Exit (PL7.1.16)?
10
SWITCH ASSY I/L REAR (PL10.1.7) ANALYSIS
1. Use SENSOR/ SWITCH CHECK to check the function of
the Switch Assy I/L Rear.
2. Open and close the Cover Rear (PL1.2.5).
Does the Switch Assy I/L Rear function correctly and
increment the Sensor Check number on the screen each
time you actuate it?
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0
Actions and Questions
S
ensor?
Primary FIPs:Error Codes
3.8 E4-3:Exit JAM continued
Yes
Go to step 7.
Go to step 9.
Replace the
Motor Assy
Exit
(RRP7.1.7).
Go to step 10.
Replace the
PWBA HKB26
MCU
(RRP10.1.7).
No
Replace the
Fuser Assy
(RRP6.1.3).
Go to step 8.
Replace the
PWBA HKB26
MCU
(RRP10.1.7).
Replace the
Actuator Full
Stack
(RRP7.1.2) or
replace the
Sensor
Photo:Exit
(RRP7.1.5).
Replace the
Cover Rear
(PL1.2.5).
3-19