Oki B6100 Technical Manual page 152

Adjustment Mode
1.6.2 Registration Adjustment
You can set the registration top to bottom (paper feed direction) and side to side (scan direction) for
each paper tray and feeder attached to the printer.
Before starting the registration adjustment, make sure the stock in each tray is properly loaded. All
guides are in the proper position, the stock is flat and clean (no bent corners) etc. Set the size and
type for each tray (see 1.6.1).
If you have any problems navigating through the menus, see Section 8.
1. Enter the diagnostic menu. Use the Next Button to scroll down to the Test Print Menu press
Select.
2. With Default Source displayed, Press Select.
3. Use the Next Button to display the tray or feeder you wish to adjust, then press Select.
4. Press Return until Test Print/Default Source is displayed. Use the Next Button to scroll down until
Grid Page is displayed. Press Select.
5. A Grid Page will be printed. Mark the page with the tray or feeder that was used.
6. Use the Next or Previous Button to scroll until Default Source is displayed. Press Select.
7. Repeat steps 3 through 6 until you have a grid test pattern from each tray or feeder. Then go to
step 8.
8. Compare the upper left corner of each document with Figure 1. Only the longest line on the lead
edge and side edge should touch the edge of the paper.
9. If all test patterns meet specification, exit this procedure. If not, go to step 10.
10. Press Return until Diagnostics/Test Print is displayed. Use the Next / Previous Button to scroll
until Alignment is displayed. Press Select.
11. The alignment menu lists each tray/feeder and feed direction and scan direction. Use the Next
Button to scroll to the tray/feeder and the direction where registration is mis-adjusted. Press
Select.
9-4
Figure 1. Registration Adjustment
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0