Oki B6100 Technical Manual page 343

Removal
1. Remove the Cover Assy Front (RRP 1.1.8).
2. Remove the Cover Front L/H (RRP 1.1.10).
3. Remove the Cover Assy Rear (RRP 1.2.3).
4. Remove the Fuser Assy (RRP 6.1.3).
5. Remove the Cover Assy I/F (RRP 1.1.2).
6. Remove the Cover Left (RRP 1.1.1).
7. Remove the Cover Assy Top (RRP 1.1.4).
8. Remove the Chute MBF Assy (RRP 4.1.1).
9. Remove the Shaft 14 (RRP 5.1.10).
10. Remove the Gear 14 (RRP 5.1.10).
11. Remove the P/H Assy (RRP 5.1.1).
12. Remove the Chute Trans Assy (RRP 6.1.2).
13. Remove the Plate Assy Left (RRP 9.1.1).
14. Remove the CRU Top Guide Assy (RRP 8.1.1)
15. Remove the Plate Handle (RRP 9.1.3).
16. Remove the PWBA HKB26 MCU (RRP 10.1.7).
17. Remove the Motor Assy Main (RRP 8.1.4)
18. Remove the PWBA HKB PS (RRP 10.1.9).
19. Remove the Gear Assy Drive (RRP 8.1.3).
20. Unplug the connector (P/J34) from the PWBA HKB26 MCU (PL10.1.13).
In the following steps, do not detach the Harness Assy DUP-M and the printer far
away because they are connected with the harness.
21. Remove the two screws securing the Harness Assy DUP-M to the printer.
22. Detach the harness of Harness Assy DUP-M a little from the printer.
23. Draw the harness of Harness Assy DUP-M from the hole in the printer.
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0
RRP 10.1.4 Harness Assy DUP-M (PL10.1.9) continued
Removal and Replacement Procedures (RRPs)
10-189