Wiring Diagrams and Interconnections
Wiring Diagram Notations
The wiring diagrams presented in this manual use the following circuit notations to describe components
and signal paths within the printer.
A PLUG
A JACK
CONNECTION OF PIN 15 OF CONNECTORS P28
AND J28.
THE SIGNAL NAME OF A WIRE
THE VOLTAGE MEASURED WITH THE NEGATIVE
PROBE OF THE METER ON SG
THE VOLTAGE VALUE OF A SIGNAL
/ = The voltage goes LOW when the signal is ON.
In this case, the HEAT signal is ON, so the normal volt-
age of 3.3VDC drops to 0VDC.
SG
SIGNAL GROUND
FG
FRAME GROUND
RTN
RETURN
There is continuity between SG and RTN. Con-
tinuity between FG and SG depends on circuit
specifications.
TTL
TTL displayed in the HIGH level or LOW level
columns of the signal tables indicate the signal
is ECL_CMOS compatible.
HIGH is approx. 3.3 VDC
LOW is approx. 0 to 0.8 VDC
14-4
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0