Preparation; Work Notes - Oki B6100 Technical Manual

Section 10 - Removal and Replacement Procedures (RRPs)
This section contains the removal and replacement procedure for main parts of the OKI B6100
printer.

Preparation

1. Switch OFF the main power.
2. Disconnect the AC power cord from the wall outlet, then start work.
3. Remove the Cassette Assy .
4. Open the Cover Front.
5. Remove the EP cartridge and store it at a dark and safety place free from direct sunlight.
6. In performing work for the FUSER ASSY periphery, wait until the FUSER ASSY and its
periphery have become cool enough.
7. Disconnect all interface cables from the rear panel of printer.
8. In performing work, to eliminate static electricity in your body, wear wristbands, etc. to
take grounding properly.

Work Notes

Many kinds of screws are used, and do not confuse where they are used. Using
wrong screws could cause the tapped holes to be broken, or troubles to occur.
In performing work with parts that are managed as spare parts but its procedure is
not given, make sure how the parts have been mounted before starting work.
Optional parts, as a rule, should be removed, but they may be left in the printer,
on condition that they do not obstruct your work.
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0
Removal and Replacement Procedures (RRPs)
10-5