Oki B6100 Technical Manual page 25

Code
--
Message
E2
There is a paper jam at the Sensor Photo:Regi.
--
The paper actuates the Sensor Photo:Regi too
early.
E2-0:EARLY-
FEED JAM
E2
There is a paper jam at the Sensor Photo:Regi.
--
The paper does not reach the Sensor Photo:Regi
within the specified time.
E2-1:MIS-
FEED JAM
C5
Tray 1/2/3 is out of paper.
--
The Sensor Photo:No Pap1/2/3 on the PWBA
Feeder (PL3.1.36) is actuated.
C5:ADD
PAPER TO
TRAY1/2/3
C5
The paper fed from the Tray 1/2/3 is different from
the NVM set size.
--
C5:ILLEGAL
SIZE
C3
Tray 1 is not installed or installed not in the posi-
tion.
--
C3:TRAY1
OUT INSTALL
TRAY
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0
Cause
Primary FIPs:Error Codes
OKI B6100 Error Codes continued
Results
-------------
How to Clear the Code
(If you cannot clear the code, go to the
appropriate error code FIP, or to the
option service manual)
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Open the Cover Assy Front.
Remove the jammed paper.
Close the Cover Assy Front.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Open the Cover Assy Front.
Remove the jammed paper.
Close the Cover Assy Front.
The printer completes only the current
print cycle.
-------------
ADD the paper to the Tray 1/2/3.
The printer completes only the current
print cycle.
-------------
Replace the stacked paper and reload
the correct size paper.
Motor Assy Main, Laser Scanner, and
Fuser Assy controls stop immediately.
-------------
Reinstall Tray 1 completely.
3-5