Oki B6100 Technical Manual page 424

Principles of Operation
3- Paper Feeder (PL 3)
Clutch Assy Turn
Clutch Assy Feed
Feeder Assy
Roll Assy Turn
PWBA Feeder
Actuator N/P
Sensor Photo:Low Paper
Sensor Photo:Face Control Detects the state that the paper level (the position of the top sheet of
13-26
Consists of a gear and an electric clutch. This is located on the end of a
shaft of the Roll Assy Turn. This clutch controls the transmission of the
drive power from the Gear Assy drive to the Roll Assy Turn by turning on
and off the clutch magnet. When this clutch is activated, the drive power is
transmitted to the Roll Assy Turn through the idle gears to the gear of the
Clutch Assy Feed (See Figure 17. Drive Transmission to the Feed assy).
Consists of a gear and a electric clutch. This is located on the end of a
shaft of the Feeder Assy. This clutch controls the transmission of the drive
power from the Gear Assy drive through the Clutch Assy Turn to the Roll
Assy of the Feeder Assy by turning on and off the clutch magnet. When
this clutch is activated, the drive power is transmitted to the Feeder Assy.
Consists of the Support Assy Nudger, Shaft Feed and Roll Assy. The task
of this assy is to pick the paper from the Cassette Assy and feed it to the
Roll Assy Turn. To ensure this task, the Support Assy Nudger acts as the
actuator for the Sensor Photo:Face Control by swivelling itself up and
down synchronizingthe hight of the stacked paper.
This assy feed the paper to the Regi position of the P/H assy. The
mechanical activity is same as the Clutch Assy Turn.
Connective interface between the Sensor Photos, the Clutches and
Motor, and the PWBA Size 1 (or PWBA Size Option for the optional
feeder). This PWBA also have the Sensor Photo: No Pap 1 which detects
the out of paper of the Cassette when it shielded the sensing point by the
Actuator N/P.
Actuates the Sensor Photo:No Pap 1. When out of paper, this actuator will
swivel down and shield the Sensor Photo:No Pap 1.
Detects the state of low paper of the Cassette Assy.
paper) goes near not so high to be able to feed.This sensor is actuated
by the Support Assy Nudger.
OKI B6100 Laser Printer - Base Engine Technical Manual
Version 1.0