Mac-Based Access Control (Mac) Commands; Enable Mac_Based_Access_Control - D-Link xStack DGS-3400 Cli Manual

xStack
MAC-
The MAC-based Access Control (MAC) commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command

enable mac_based_access_control

disable mac_based_access_control
config mac_based_access_control password
config mac_based_access_control method
config mac_based_access_control guest_vlan
ports
config mac_based_access_control ports
create mac_based_access_control
delete mac_based_access_control
clear mac_based_access_control auth_state
create mac_based_access_control_local mac
config mac_based_access_control_local mac
delete mac_based_access_control_local
show mac_based_access_control
show mac_based_access_control_local
show mac_based_access_control auth_state
config mac_based_access_control
auth_failover
config mac_based_access_control
authorization network
config mac_based_access_control max_users
Each command is listed, in detail, in the following sections.
enable mac_based_access_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
A
BASED CCESS
Parameters
<passwd 16>
[local | radius]
<portlist>
[<portlist> | all] {state [enable | disable] | mode [port_based |
host_based] | aging_time [infinite | <min 1–1440>] | block_time
[infinite|<sec 1-300>] | max_users [no_limit |<value 1-4000>]}
(1)
[guest_vlan <vlan_name 32>| guest_vlanid <vlanid 1–4094>]
[guest_vlan <vlan_name 32>|guest_vlanid <vlanid 1–4094>]
[ports [all | portlist] | mac_addr <macaddr>]
<macaddr> [vlan <vlan_name 32>|vlanid <vlanid 1–4094>]
<macaddr> [vlan <vlan_name 32>|vlanid <vlanid 1–4094> |
clear_vlan]
[mac <macaddr> | vlan <vlan_name 32>|vlanid <vlanid 1–
4094>]
{ports {<portlist> }}
{[mac<macaddr> | [vlan <vlan_name 32>|vlanid <vlanid 1–
4094>]]}
ports <portlist>
[enable | disable]
{radius [enable | disable] | local [enable | disable]} (1)
[<value 1-4000> | no_limit]
Used to enable MAC-based access control.
enable mac_based_access_control
This command is used to enable the MAC-based access control function.
None.
Only Administrator and Operator-level users can issue this command.
C
ONTROL
355
(MAC) C
OMMANDS
48