Mac-Based Access Control Commands - D-Link DGS-1210/ME series Reference Manual

MAC-BASED ACCESS CONTROL COMMANDS

The MAC-Based Access Control commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
enable
mac_based_access_control
disable
mac_based_access_control
config
mac_based_access_control
password
config
mac_based_access_control
method
config
mac_based_access_control port
config
mac_based_access_control trap
state
config
mac_based_access_control log
state
config
mac_based_access_control
max_users
create
mac_based_access_control_local
mac_address
show mac_based_access_control
show
mac_based_access_control_local
show
mac_based_access_control_local
auth_state ports
delete
mac_based_access_control_local
mac_address
Each command is listed in detail, as follows:
DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide
Parameter
<passwd 16>
[local | radius]
[<portlist> | all] {state [enable | disable] | aging_time [infinite | <value
1-1440>] | block_time <value 0-300>}
[enable | disable]
[enable | disable]
<value 1-1000>
<mac_addr> vlanid <int 1-4094>
{port [<portlist> | all]}
{mac_address <mac_addr> | vlanid <int 1-4094>}
[<portlist> | all]
<mac_addr> vlanid <int 1-4094>
238
31