Debug Stp Config Ports; Debug Stp Show Counter - D-Link xStack DGS-3420 Series Reference Manual
Layer 2 managed stackable gigabit switch cli
Hide thumbs
Also See for xStack DGS-3420 Series:
- Reference manual (499 pages) ,
- Hardware installation manual (53 pages) ,
- How to set up (2 pages)
Table of Contents
Advertisement
xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
19-10 debug stp config ports
Description
This command used to configure per-port STP debug level on the specified ports.
Format
debug stp config ports [<portlist> | all] [event | bpdu | state_machine | all] state [disable | brief |
detail]
Parameters
ports - Specifies the STP port range to debug.
<portlist> - Enter the list of port used for this configuration here.
all - Specifies to debug all ports on the switch.
event - Debug the external operation and event processing.
bpdu - Debug the BPDU's that have been received and transmitted.
state_machine - Debug the state change of the STP state machine.
all - Debug all of the above.
state - Specifies the state of the debug mechanism.
disable - Disables the debug mechanism.
brief - Sets the debug level to brief.
detail - Sets the debug level to detail.
Restrictions
Only Administrator level users can issue this command.
Example
To configure all STP debug flags to brief level on all ports:
DGS-3420-28SC:admin# debug stp config ports all all state brief
Command: debug stp config ports all all state brief
Success.
DGS-3420-28SC:admin#
19-11 debug stp show counter
Description
This command used to display the STP counters.
Format
debug stp show counter {ports [<portlist> | all]}
250
Advertisement
Table of Contents
