Show Fiber-Ports Optical-Transceiver - Dell N1100-ON Reference Manual

Gi1/0/1 OK
Gi1/0/2 Short
Gi1/0/3 Test has not been performed
Gi1/0/4 Open
Gi1/0/5 Fiber

show fiber-ports optical-transceiver

Use the show fiber-ports optical-transceiver command to display the optical
transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [interface]
• interface — A valid SFP, XFP or SFP+ port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged Exec mode, Global Configuration mode and all Configuration
submodes
User Guidelines
The show fiber ports command is applicable to all fiber ports, including SFP,
SFP+, and XFP ports. It will display an error if executed against a copper port
or passive or active direct attach cables.
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port Temp Voltage Current Power
[C] [Volt]
--------- ---- ------- ------- ------- ------- ----- ---
Te2/0/23 22.5 3.296
50
128
-
Output
[mA] [dBm]
7.5 -2.184 -36.990 No
13:32:00 23 July 2004
13:32:08 23 July 2004
-
Input
Power TX LOS
[dBm] Fault
Yes
Switch Management Commands
1987