Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3565

Table 460: show link-management routing Output Fields (continued)
Field Name Field Description
State of the control channel.
State
Traffic-engineered link name.
TE link name
State of the traffic-engineered link:
State
Identifier of the local side of the link.
Local identifier
Identifier of the remote side of the link.
Remote identifier
Address of the local side of the link.
Local address
Address of the remote side of the link.
Remote address
Encoding Physical layer media type determined by the interfaces contained in the traffic-engineered link. Typical
values include
Minimum bandwidth Smallest single allocation of bandwidth, in bits per second (bps) or megabits per second (Mbps),
possible on the traffic-engineered link. This number is equal to the smallest bandwidth interface that
is a member of the traffic-engineered link.
Largest single allocation of bandwidth, in bps or Mbps, possible on the traffic-engineered link. This
Maximum bandwidth
number is equal to the largest bandwidth interface that is a member of the link (in bps).
Total bandwidth Sum of the bandwidth, in bps or Mbps, of all interfaces that are members of the link.
Available bandwidth Sum of the bandwidth, in bps or Mbps, of all interfaces that are members of the link and that are not
yet allocated.
Forwarding adjacency LSP information.
Resource
Type of resource. The type is always a forwarding adjacency LSP.
Type
State of the LSP:
State
Internal identifier for the peer. The range of values is
System Identifier
Bandwidth resource, in bps or Mbps, on the TE-link learned from the routing process.
Total bandwidth
Traffic parameters
Copyright © 2010, Juniper Networks, Inc.
SDH/SONET , Ethernet
or .
Up Down
—Physical layer media type determined by the interfaces contained in the traffic-engineered
Encoding
link. Typical values include
SDH/SONET
—Type of switching that can be performed on the traffic-engineered link:
Switching
.
Packet
Granularity —Layer 2 data for switching Layer 2 LSPs for this resource. Not supported. This value is
always unknown .
Chapter 126: Operational Mode Commands for MPLS
or .
Up Down
, and Packet .
through
0 64,000
, , and .
Ethernet Packet
.
and
PSC-1
3469