Configuration Statements For Sflow Technology - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Related
Documentation

Configuration Statements for sFlow Technology

Copyright © 2010, Juniper Networks, Inc.
NOTE: You cannot enable sFlow technology on a Layer 3 VLAN-tagged
interface.
You cannot enable sFlow technology on a link aggregation group (LAG),
but you can enable it on the member interfaces of a LAG.
Specify how often the sFlow agent polls the interface:
4.
[edit protocols sflow]
user@switch# set polling-interval seconds
NOTE: Specify
Specify the rate at which packets must be sampled:
5.
[edit protocols sflow]
user@switch# set sample-rate number
To configure the polling interval and sample rate at the interface level:
6.
[edit protocols sflow interfaces interface-name]
user@switch# set polling-interval seconds
[edit protocols sflow interfaces]
user@switch# set sample-rate number
NOTE: The interface-level configuration overrides the global configuration.
To specify an IP address to be used as the agent ID for the sFlow agent:
7.
[edit protocols sflow]
user@switch# set agent-id ip-address
To specify the source IP address to be used for sFlow datagrams:
8.
[edit protocols sflow]
user@switch# set source-ip ip-address
Example: Configuring sFlow Technology to Monitor Network Traffic on EX Series
Switches on page 3579
Understanding How to Use sFlow Technology for Network Monitoring on an EX Series
Switch on page 3577
[edit protocols] Configuration Statement Hierarchy on page 3586
Chapter 128: sFlow Monitoring Technology
if you do not want to poll the interface.
0
3585