Table of Contents
Advertisement
show rsvp neighbor
Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Table 473: show rsvp neighbor Output Fields
Field Name
Field Description
Number of neighbors that the routing device has learned of. Each neighbor has
RSVP neighbor
one line of output.
Name of the interface where the neighbor has been detected. In the case of
via
generalized MPLS (GMPLS) LSPs, the name of the peer where the neighbor
has been detected.
Address of a learned neighbor.
Address
Length of time the neighbor has been idle, in seconds.
Idle
Number of neighbor up or down transitions detected by RSVP hello packets. If
Up/Dn
the up count is 1 greater than the down count, the neighbor is currently up.
Otherwise, the neighbor is down. Neighbors that do not support RSVP hello
packets, such as routers running Junos OS Release 3.2 or earlier, are not reported
as up or down.
Copyright © 2010, Juniper Networks, Inc.
show rsvp neighbor
<brief | detail>
<logical-system (all | logical-system-name)>
show rsvp neighbor
<brief | detail>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.5 for EX Series switches.
Display Resource Reservation Protocol (RSVP) neighbors that were discovered
dynamically during the exchange of RSVP packets.
—Display standard information about RSVP neighbors.
none
brief | detail
—(Optional) Display the specified level of output.
logical-system (all | logical-system-name)
systems or on a particular logical system.
view
show rsvp neighbor on page 3509
show rsvp neighbor detail on page 3509
Table 473 on page 3505 lists the output fields for the
fields are listed in the approximate order in which they appear.
Chapter 126: Operational Mode Commands for MPLS
—(Optional) Perform this operation on all logical
show rsvp neighbor
command. Output
Level of Output
All levels
detail
All levels
All levels
All levels
3505
Advertisement
Chapters
Table of Contents
Troubleshooting
