Show Connections; Table 456: Show Connections Output Fields - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Complete Software Guide for Junos
Required Privilege
Level
Output Fields
3456
®
OS for EX Series Ethernet Switches, Release 10.3
—(Optional) Display labels used for transmit and receive.
labels
logical-system (all | logical-system-name)
systems or on a particular logical system.
—(Optional) Display information about the specified connection only.
name
status —(Optional) Display information about the connection and interface status.
view
Table 456 on page 3456 describes the output fields for the
Output fields are listed in the approximate order in which they appear.

Table 456: show connections Output Fields

Field Name Field Description
Whether link monitoring is enabled:
CCC and TCC
connections [Link
Monitoring On I
Off]
Legend for Status Connection or circuit status. See the output's legend for an explanation of the
status field values.
(St)
Legend for Type of connection:
connection types
if-sw
rmt-if
will display a state
lsp-sw
lsp-sw
Type of circuits:
Legend for circuit
types
intf
tlsp
rlsp
Name of the configured CCC connection.
Connection/Circuit
Type of connection.
Type
St State of the connection.
Time last up Time that the connection or circuit last transitioned to the
state.
# Up trans Number of times that the connection or circuit has transitioned to the
(operational) state.
—(Optional) Perform this operation on all logical
—Layer 2 switching cross-connect.
—Remote interface switch. While graceful restart is in progress,
of
(St) Restart
—LSP stitching cross-connect. While graceful restart is in progress,
will display a state of
(St)
—Interface circuit.
—Transmit LSP circuit.
—Receive LSP circuit.
command.

show connections

or .
On Off
.
.
Restart
Up (operational)
Copyright © 2010, Juniper Networks, Inc.
rmt-if
Up