Juniper JUNOS OS 10.3 - SOFTWARE Manual page 3613

Table 475: show rsvp session Output Fields (continued)
Field Name Field Description
Destination (egress routing device) of the session.
To
Source (ingress routing device) of the session.
From
State of the path:
State
being taken down gracefully.
Destination (egress routing device) of the LSP.
Address
From Source (ingress routing device) of the session.
LSPstate State of the LSP that is being handled by this RSVP session. It can be either
(down), or
Dn
gracefully.
Rt Number of active routes (prefixes) that have been installed in the routing table.
For ingress RSVP sessions, the routing table is the primary IPv4 table (
For transit and egress RSVP sessions, the routing table is the primary MPLS table
mpls.0
Active Route Number of active routes (prefixes) that have been installed in the forwarding
table. For ingress RSVP sessions, the forwarding table is the primary IPv4 table
(
inet.0
MPLS table (
Name of the LSP.
LSPname
Indicates whether the RSVP session is for the primary or secondary LSP path.
LSPpath
LSPpath
egress, and transit routing devices.
LSP deletion has been triggered.
(Egress routing device) Destination address for the bypass LSP.
Bypass
(When LSP is bidirectional) LSP will allow data to travel in both directions
Bidir
between GMPLS devices.
Bidirectional (When LSP is bidirectional) LSP will allow data to travel both ways between
GMPLS devices.
(When LSP is bidirectional) Incoming label for reverse direction traffic for
Upstream label in
this LSP.
(When LSP is bidirectional) Outgoing label for reverse direction traffic for
Upstream label out
this LSP.
(When LSP is bidirectional) Label the upstream node suggests for use in the
Recovery label
Resv message that is sent.
received
Copyright © 2010, Juniper Networks, Inc.
, , or
Up Down AdminDn
. indicates that the LSP is being taken down
AdminDn AdminDn
).
). For transit and egress RSVP sessions, the forwarding table is the primary
).
mpls.0
can be either or
primary secondary
LSPpath
Chapter 126: Operational Mode Commands for MPLS
. indicates that the LSP is
AdminDn
and can be displayed on the ingress,
can also indicate when a graceful
Level of Output
All levels
All levels
All levels
detail
detail
Up , brief detail
brief
inet.0 ).
detail
brief detail
detail
detail
detail
detail
detail
detail
detail
3517