Displaying Qos Information - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring QoS
Configure marked-down DSCP values that map to CoS values consistent with the markdown penalty
Note
(see the
To revert to default DSCP markdown value mapping, perform this task in privileged mode:
Task
Step 1 Revert to DSCP markdown map defaults.
Step 2 Verify the configuration.
This example shows how to revert to DSCP markdown map defaults:
Console> (enable) clear qos policed-dscp-map
QoS dscp-cos-map setting restored to default.
Console> (enable)
Without the normal-rate or the excess-rate keywords, the clear qos policed-dscp-map command
Note
clears only the normal policed-dscp map.

Displaying QoS Information

To display QoS information, perform this task:
Task
Display QoS information.
This example shows how to display the QoS runtime information for port 2/1:
Console> show qos info config 2/1
QoS setting in NVRAM:
QoS is enabled
Port 2/1 has 2 transmit queue with 2 drop thresholds (2q2t).
Port 2/1 has 1 receive queue with 4 drop thresholds (1q4t).
Interface type:vlan-based
ACL attached:
The qos trust type is set to untrusted.
Default CoS = 0
Queue and Threshold Mapping:
Queue Threshold CoS
----- --------- ---------------
1
1
2
2
Rx drop thresholds:
Rx drop thresholds are disabled for untrusted ports.
Queue #
-------
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
41-58
"Mapping Internal DSCP Values to Egress CoS Values" section on page
1 0 1
2 2 3
1 4 5
2 6 7
Thresholds - percentage (abs values )
-------------------------------------
Command
clear qos policed-dscp-map
[normal-rate | excess-rate]
show qos maps {config | runtime}
[cos-dscp-map | ipprec-dscp-map |
dscp-cos-map | policed-dscp-map]
Command
show qos info [runtime | config]
Chapter 41 Configuring QoS
41-56).
78-13315-02