Displaying Auto-Qos Information - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 30 Configuring QoS
To disable auto-QoS on the switch and return to the default port trust state set (untrusted), follow these
steps:
1.
2.
To display the QoS commands that are automatically generated when auto-QoS is enabled or disabled,
enter the debug auto qos privileged EXEC command before enabling auto-QoS. For more information,
see the
This example shows how to enable auto-QoS and to trust the QoS labels in incoming packets when the
device connected to the interface is detected as a Cisco IP Phone:
Switch(config)# interface fastethernet0/1
Switch(config-if)# auto qos voip cisco-phone
This example shows how to enable auto-QoS and to trust the QoS labels in incoming packets when the
switch or router connected to the interface is a trusted device:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# auto qos voip trust

Displaying Auto-QoS Information

To display the initial auto-QoS configuration, use the show auto qos [interface [interface-id]]
privileged EXEC command. To display any user changes to that configuration, use the show
running-config privileged EXEC command. You can compare the show auto qos and the show
running-config command output to identify the user-defined QoS settings.
To display information about the QoS configuration that might be affected by auto-QoS, use one of these
commands:
•
•
•
•
For more information about these commands, refer to the command reference for this release.
78-11380-10
Use the no auto qos voip interface configuration command on all interfaces on which auto-QoS is
enabled. To disable auto-QoS on multiple interfaces at the same time, you can use the interface
range global configuration command.
After disabling auto-QoS on all interfaces on which auto-QoS was enabled, return the egress queues
and CoS-to-DSCP map to the default settings by using these global configuration commands:
no wrr-queue bandwidth
•
no wrr-queue cos-map
•
• no mls qos map cos-dscp
"Using the debug auto qos Command" section on page
show mls qos
show mls qos map cos-dscp
show wrr-queue bandwidth
show wrr-queue cos-map
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Displaying Auto-QoS Information
32-21.
30-15