Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 347

Chapter 16 Configuring Access Control
To specify an adjacency table entry for the PFC2, perform this task in privileged mode:
Task
Specify an adjacency table entry for the PFC2.
This example shows how to specify the adjacency table entry:
Console> (enable) set security acl adjacency ADJ1 11 00-00-00-00-00-0B
ADJ1 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable)
This example shows how to create the PBF VACL for VLAN 10 (shown in
Console> (enable) set security acl adjacency ADJ1 11 00-00-00-00-00-0B
ADJ1 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable) set security acl ip IPACL1 redirect ADJ1 ip host 10.0.0.1 host 11.0.0.1
IPACL1 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable) set security acl ip IPACL1 permit any
IPACL1 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable) commit security acl adjacency
Commit operation in progress.
Adjacency successfully committed.
Console> (enable) commit security acl IPACL1
ACL commit in progress.
ACL 'IPACL1' successfully committed.
Console> (enable) set security acl map IPACL1 10
Mapping in progress.
ACL IPACL1 successfully mapped to VLAN 10.
Console> (enable)
This example shows how to create the PBF VACL for VLAN 11 (see
Console> (enable) set security acl adjacency ADJ2 10 00-00-00-00-00-0A
ADJ2 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable) set security acl ip IPACL2 redirect ADJ2 ip host 11.0.0.1 host 10.0.0.1
IPACL2 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable) set security acl ip IPACL2 permit any
IPACL2 editbuffer modified. Use 'commit' command to apply changes.
Console> (enable) commit security acl adjacency
Commit operation in progress.
Adjacency successfully committed.
Console> (enable) commit security acl IPACL2
ACL commit in progress.
ACL 'IPACL2' successfully committed.
Console> (enable) set security acl map IPACL2 11
Mapping in progress.
ACL IPACL2 successfully mapped to VLAN 11.
Console> (enable)
78-13315-02
Command
set security acl adjacency adjacency_name
dest_vlan dest_mac [[source_mac] |
[source_mac mtu mtu_size] | [ mtu mtu_size]]
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring Policy-Based Forwarding
Figure 16-8):
Figure 16-8):
16-51