Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 744

Configuring QoS
Named IP ACLs
These sections describe creating or modifying IP ACLs:
•
•
•
•
•
•
•
•
•
Source and Destination IP Addresses and Masks
In IP ACEs, specify source and destination IP addresses and masks (represented by the src_ip_spec and
dest_ip_spec parameters in the following sections) in the form ip_address mask. The mask is mandatory.
Use one bits, which need not be contiguous, where you want wildcards.
Use any of the following formats for the address and mask:
•
•
•
Port Operator Parameters
In IP ACEs, the operator parameter can be one of the following:
•
•
•
•
•
See the
QoS ACLs.
Precedence Parameter Options
For precedence parameter keyword options in IP ACEs, see the
section on page
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
41-38
Source and Destination IP Addresses and Masks, page 41-38
Port Operator Parameters, page 41-38
Precedence Parameter Options, page 41-38
IP ACEs for TCP Traffic, page 41-39
IP ACEs for UDP Traffic, page 41-39
IP ACEs for ICMP Traffic, page 41-40
IP ACEs for IGMP Traffic, page 41-40
IP ACLs for Other Layer 4 Protocols, page 41-41
IP ACEs for Any IP Traffic, page 41-41
Four-part dotted-decimal 32-bit values
The keyword any as an abbreviation for a wildcard address and wildcard mask of 0.0.0.0
255.255.255.255
The abbreviation host ip_address for an address and wildcard mask of ip_address 0.0.0.0
lt (less than)
gt (greater than)
eq (equal)
neq (not equal)
range (with a pair of port parameters)
"Guidelines for Using Layer 4 Operations" section on page 16-20
41-16.
Chapter 41
for restrictions that apply to
"IP ACE Layer 3 Classification Criteria"
Configuring QoS
78-13315-02