Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 793

Chapter 42 Configuring ASLB
This example shows how to specify MAC addresses for participating routers:
Console> (enable) set lda mac router 00-23-45-67-ee-7f
Successfully set mac address.
Use commit lda command to save settings to hardware.
Console> (enable)
Specifying a MAC Address for the LocalDirector
To specify a MAC address for the LocalDirector, perform this task in privileged mode:
Task
Specify a MAC address for the LocalDirector. set lda mac ld {ld_mac-address}
This example shows how to specify a MAC address for the LocalDirector:
Console> (enable) set lda mac ld 00-11-22-33-55-66
Successfully set mac address.
Use commit lda command to save settings to hardware.
Console> (enable)
Specifying the Router VLAN and the LocalDirector Port on the VLAN
After entering the set lda router command, if you change the switch port(s) that the LocalDirector
Note
is connected to, you must enter the set lda router command again to specify the new configuration.
Specifying a backup LocalDirector port is optional unless you are setting up a failover configuration
Note
of LocalDirectors. If you are setting up a failover configuration, you must specify the ports for the
backup LocalDirector. If this is not done, failover will not work because the supervisor engine will
not send any traffic to the intended backup LocalDirector.
To specify the VLAN the router is on and the LocalDirector port on the VLAN, perform this task in
privileged mode:
Task
Specify the router VLAN and the
LocalDirector port on the VLAN.
This example shows how to specify the router VLAN and the LocalDirector port on the VLAN:
Console> (enable) set lda router 110 4/26
Successfully set router vlan and LD port.
Use commit lda command to save settings to hardware.
Console> (enable)
78-13315-02
Command
Command
set lda router {router_vlan} {ld_mod/port}
[backup_ld_mod/port]
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring ASLB
42-13