Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 39

Chapter 2 Command-Line Interfaces
After accessing the switch through the console port, you see this display:
Cisco Systems Console
Enter password:
Console>
Accessing the CLI through Telnet
Before you can open a Telnet session to the switch, you must first set the IP address for the switch. For
information about setting the IP address, see the
section on page
automatically after remaining idle for a set time period.
To access the switch CLI from a remote host using Telnet, perform this task:
Task
Step 1 From the remote host, enter the telnet command
and the name or IP address of the switch you want
to access.
Step 2 At the prompt, enter the password for the CLI. If
no password has been configured, press Return.
Step 3 Enter the necessary commands to complete your
desired tasks.
Step 4 When finished, exit the Telnet session.
This example shows how to open a Telnet session to the switch:
unix_host% telnet Catalyst_1
Trying 172.16.10.10...
Connected to Catalyst_1.
Escape character is '^]'.
Cisco Systems Console
Enter password:
Catalyst_1>
Accessing the MSFC from the Switch
These sections describe how to access the Multilayer Switch Feature Card (MSFC) from a directly
connected console port or from a Telnet session:
•
•
See the
78-13315-02
3-5. Up to eight simultaneous Telnet sessions are supported. Telnet sessions disconnect
Accessing the MSFC from the Console Port, page 2-4
Accessing the MSFC from a Telnet Session, page 2-4
"MSFC Command-Line Interface" section on page
"Assigning the In-Band (sc0) Interface IP Address"
Command
telnet {hostname | ip_addr}
—
—
exit
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Catalyst Command-Line Interface
2-8.
2-3