Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 523

Chapter 22 Configuring Redundancy
##########################################################################################
##########################################################################################
##########################################################################################
##########################################################################################
##########################################################################################
### [OK]
At the ROMMON prompt, enter the confreg command:
Step 3
Enter y at the "do you wish to change the configuration? y/n [n]:" prompt
a.
Press Enter to accept the default for all questions until you reach this prompt: "change the boot
b.
characteristics? y/n [n]:"
Enter y
c.
Enter 0 to select the "0 = ROM Monitor" option at the next prompt
d.
e. Review the Configuration Summary to ensure the following value: boot: the ROM Monitor
f. You are again prompted with: "do you wish to change the configuration? y/n [n]:"
g. Enter n
h. You are returned to the ROMMON prompt
Enter the reset command and verify that the MSFC boots into ROMMON. This step ensures that this
Step 4
MSFC and the active MSFC will not boot concurrently.
Step 5 Enter ^C^C^C to return to the supervisor engine prompt.
Ensure that high availability has synchronized the supervisor engine state by entering the show system
Step 6
highavailability command and verifying that high availability "Operational-status" is ON.
Step 7 Enter the switch supervisor command.
Enter the switch console command.
Step 8
From the standby MSFC's ROMMON prompt, perform step 3 above but in step 3d, select option 2 "boot
Step 9
system" as follows:
change the boot characteristics? y/n
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
[2]:
Configuration Summary
enabled are:
load rom after netboot fails
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
You must reset or power cycle for new config to take effect
rommon 2 >
Enter the reset command at the ROMMON prompt to boot the system.
Step 10
After the MSFC has booted from the IOS configuration mode on the newly active MSFC's console port,
Step 11
enter the config-register 0x2102 command.
78-13315-02
2 <========================
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
[n]: y
[n]: n
MSFC Redundancy
22-49