Automatically Moving The Vacl And Qos Acl Configuration To Flash Memory - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 16 Configuring Access Control
This section describes the following tasks:
•
•
•
•
•
•
See
Note
commands described in this section.

Automatically Moving the VACL and QoS ACL Configuration to Flash Memory

Moving the VACL and QoS ACL configuration to Flash memory is done automatically only during
system software upgrades and then only if there is not sufficient NVRAM for the upgrade. If there is not
enough NVRAM to perform a software upgrade, the QoS ACL and VACL configuration is deleted from
NVRAM and the ACL configuration is automatically moved to Flash memory. When this occurs, these
syslog messages display:
1999 Sep 01 17:00:00 %SYS-1-CFG_FLASH:ACL configuration moved to bootflash:switchapp.cfg
1999 Sep 01 17:00:00 %SYS-1-CFG_ACL_DEALLOC:NVRAM full. Qos/Security ACL configuration
deleted from NVRAM.
The VACL and QoS ACL configuration has now been successfully moved to Flash memory. During this
process, the system also does the following:
•
•
If an error occurs during the upgrade, these syslog messages display:
1999 Sep 01 17:00:00 %SYS-1-CFG_FLASH_ERR:Failed to write ACL configuration to
bootflash:switchapp.cfg
1999 Sep 01 17:00:00 %SYS-1-CFG_ACL_DEALLOC:NVRAM full. Qos/Security ACL configuration
deleted from NVRAM.
If you receive these error messages, the VACL and QoS ACL configuration is stored in DRAM only.
You need to make more space available in Flash memory and then save the configuration to Flash
memory (as described in the
on page
configuration to NVRAM using the set config acl nvram command.
78-13315-02
Automatically Moving the VACL and QoS ACL Configuration to Flash Memory, page 16-43
Manually Moving the VACL and QoS ACL Configuration to Flash Memory, page 16-44
Running with the VACL and QoS ACL Configuration in Flash Memory, page 16-45
Moving the VACL and QoS ACL Configuration Back to NVRAM, page 16-46
Redundancy Synchronization Support, page 16-46
Interacting with High Availability, page 16-46
Chapter 23, "Modifying the Switch Boot Configuration,"
Sets the CONFIG_FILE variable to bootflash:switchapp.cfg
Enables the set boot config-register auto-config command recurring, append, and sync options
"Moving the VACL and QoS ACL Configuration Back to NVRAM" section
16-46). Alternatively, you might try to delete unneeded VACLs and QoS ACLs and save the ACL
Configuring and Storing VACLs and QoS ACLs in Flash Memory
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
for additional information on using the
16-43