Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 277

Chapter 14 Configuring MLS
•
•
•
•
•
For information on configuring routing on the MSFC, see
Note
Routing."
You can specify the MSFC as the MLS route processor (MLS-RP) for Catalyst 5000 family switches
Note
using MLS. Refer to the Layer 3 Switching Configuration Guide—Catalyst 5000 Family, 2926G
Series, 2926 Series Switches for Catalyst 5000 family switch MLS configuration procedures.
This section describes how to enable IP multicast routing on the MSFC. For more detailed IP
Note
multicast configuration information, refer to the "IP Multicast" section of the Cisco IOS IP and IP
Routing Configuration Guide at
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ip_c/ipcprt3/index.htm
Enabling IP Multicast Routing Globally
You must enable IP multicast routing globally on the MSFC before you can enable IP MMLS on MSFC
interfaces.
To enable IP multicast routing globally on the MSFC, perform this task in global configuration mode:
Task
Enable IP multicast routing globally.
This example shows how to enable IP multicast routing globally:
Router(config)# ip multicast-routing
Router(config)#
Enabling IP PIM on MSFC Interfaces
You must enable IP PIM on the MSFC interfaces before IP MMLS will function on those interfaces.
To enable IP PIM on an interface, perform this task:
Task
Enable IP PIM on an MSFC interface. Router(config-if)# ip pim {dense-mode | sparse-mode |
78-13315-02
Displaying IP MMLS Interface Information, page 14-31
Displaying the IP Multicast Routing Table, page 14-31
Monitoring IP MMLS on the MSFC, page 14-32
Using Debug Commands on the IP MMLS MSFC, page 14-33
Using Debug Commands on the SCP, page 14-34
Chapter 12, "Configuring InterVLAN
Command
Router(config)# ip multicast-routing
Command
sparse-dense-mode}
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring MLS
14-29