Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 279

Chapter 14 Configuring MLS
Displaying IP MMLS Interface Information
The show ip pim interface count command displays the IP MMLS enable state on MSFC IP PIM
interfaces and the number of packets received and sent on the interface.
The show ip interface command displays the IP MMLS enable state on an MSFC interface.
To display IP MMLS information for an IP PIM MSFC interface, perform one of these tasks:
Task
Display IP MMLS interface information.
Display the IP MMLS interface enable state. Router# show ip interface
Displaying the IP Multicast Routing Table
The show ip mroute command displays the IP multicast routing table on the MSFC.
To display the IP multicast routing table, perform this task:
Task
Display the IP multicast routing table.
This example shows how to display the IP multicast routing table for 239.252.1.1:
Router# show ip mroute 239.252.1.1
IP Multicast Routing Table
Flags:D - Dense, S - Sparse, C - Connected, L - Local, P - Pruned
Outgoing interface flags:H - Hardware switched
Timers:Uptime/Expires
Interface state:Interface, Next-Hop or VCD, State/Mode
(*, 239.252.1.1), 04:04:59/00:02:59, RP 80.0.0.2, flags:SJ
Incoming interface:Vlan800, RPF nbr 80.0.0.2
Outgoing interface list:
(22.0.0.10, 239.252.1.1), 00:00:19/00:02:41, flags:JT
Incoming interface:Vlan800, RPF nbr 80.0.0.2, RPF-MFD
Outgoing interface list:
78-13315-02
R - RP-bit set, F - Register flag, T - SPT-bit set, J - Join SPT
M - MSDP created entry, X - Proxy Join Timer Running
A - Advertised via MSDP
Vlan10, Forward/Dense, 01:29:57/00:00:00, H
Vlan10, Forward/Dense, 00:00:19/00:00:00, H
Command
Router# show ip pim interface [type number] count
Command
Router# show ip mroute [group[source]] |
[summary] | [count] | [active kbps]
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Configuring MLS
14-31