Disabling Uplinkfast - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring UplinkFast
Console> (enable) show spantree uplinkfast 1 100 521-524
Station update rate set to 15 packets/100ms.
uplinkfast all-protocols field set to off.
VLAN
-----------------------------------------------
1
100
521
522
523
524
Console> (enable)
This example shows how to display the UplinkFast feature settings for all VLANs:
Console> show spantree uplinkfast
Station update rate set to 15 packets/100ms.
uplinkfast all-protocols field set to off.
VLAN port list
------------------------------------------------
1-20
21-50
51-100 2/1(fwd), 2/12
Console>
With MISTP mode enabled, this example shows the output when you enable UplinkFast:
Console> (enable) set spantree uplinkfast enable
Instances 1-16 bridge priority set to 49152.
The port cost and portinstancecost of all ports set to above 10000000.
Station update rate set to 15 packets/100ms.
uplinkfast all-protocols field set to off.
uplinkfast enabled for bridge.
Console> (enable)
This example shows how to display the UplinkFast feature settings for a specific instance:
Console> show spantree uplinkfast mistp-instance 1
Station update rate set to 15 packets/100ms.
uplinkfast all-protocols field set to off.
Inst
------------------------------------------------
1
Console>

Disabling UplinkFast

The set spantree uplinkfast disable command disables UplinkFast on the switch, but the switch priority
and port cost values are not reset to the factory defaults.
When you enter the set spantree uplinkfast disable command, it affects all VLANs on the switch.
Note
You cannot disable UplinkFast on an individual VLAN.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
9-14
Chapter 9
port list
1/1(fwd),1/2
1/2(fwd)
1/1(fwd),1/2
1/1(fwd),1/2
1/1(fwd),1/2
1/1(fwd),1/2
1/1(fwd),1/2-1/5
1/9(fwd), 1/6-1/8, 1/10-1/12
port list
4/1(fwd)
Configuring Spanning Tree PortFast, UplinkFast, BackboneFast, and Loop Guard
78-13315-02