Ip Mmls - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Catalyst 6000 series software configuration guide
Hide thumbs Also See for WS-X6066-SLB-APC - Content Switching Module:
Table of Contents

Advertisement

Configuration Guidelines and Restrictions
Restrictions on Using IP Routing Commands with IP MLS Enabled
Enabling certain IP processes on an interface will affect IP MLS on the interface.
affected commands and the resulting behavior.
Table 14-5 IP Routing Command Restrictions
Command
clear ip route
ip routing
ip security (all forms of this
command)
ip tcp compression-connections Disables IP MLS on the interface.
ip tcp header-compression

IP MMLS

These sections describe IP MMLS configuration guidelines:
IP MMLS Supervisor Engine Guidelines and Restrictions
These guidelines and restrictions apply when configuring Supervisor Engine 1 for IP MMLS:
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
14-12
IP MMLS Supervisor Engine Guidelines and Restrictions, page 14-12
IP MMLS MSFC Configuration Restrictions, page 14-13
Unsupported IP MMLS Features, page 14-13
Only ARPA rewrites are supported for IP multicast packets.
Subnetwork Address Protocol (SNAP) rewrites are not supported.
You must enable one of the multicast services (IGMP snooping or GMRP
use IP MMLS.
IP multicast flows are not multilayer switched if there is no entry in the Layer 2 multicast
forwarding table (for example, if no Layer 2 multicast services are enabled or the forwarding table
is full). Enter the show multicast group command to check for a Layer 2 entry for a particular IP
multicast destination.
If a Layer 2 entry is cleared, the corresponding Layer 3 flow information is purged.
When using two MSFCs that have one or more interfaces in the same VLAN, the switch uses two
reserved VLANs (VLANs 1012 and 1013) internally to forward multicast flows properly.
The MSFC will not act as an external router for a Catalyst 5000 family switch that has Layer 3
switching hardware.
Behavior
Clears all MLS cache entries for all switches performing Layer 3
switching for this MSFC.
The no form purges all MLS cache entries and disables IP MLS
on this MSFC.
Disables IP MLS on the interface.
Disables IP MLS on the interface.
Chapter 14
Configuring MLS
Table 14-5
shows the
on the switch in order to
)
78-13315-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents