Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 456

Configuring Authentication
To reset the 802.1x configuration parameters to the default values, perform this task in privileged mode:
Task
Step 1
Reset the 802.1x configuration parameters to the
default values and globally disable 802.1x.
Step 2
Verify the 802.1x configuration.
This example shows how to reset the 802.1x configuration parameters to the default values and verify
the configuration:
Console> (enable) clear dot1x config
This command will disable dot1x on all ports and take dot1x parameter values back to
factory defaults.
Do you want to continue (y/n) [n]?
Console> (enable) show dot1x
PAE Capability
Protocol Version
system-auth-control
max-req
quiet-period
re-authperiod
server-timeout
supp-timeout
tx-period
Using the show Commands
You can use these show commands to access information about 802.1x authentication and its
configuration:
•
•
•
•
To display the usage options for the show port dot1x command, perform this task in normal mode:
Task
Display the usage options for the show port
dot1x command.
This example shows how to display the usage options for the show port dot1x command:
Console> (enable) show port dot1x help
Usage: show port dot1x [<mod[/port]>]
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
21-46
show port dot1x help
show port dot1x
show port dot1x statistics
show dot1x
show port dot1x statistics [<mod[/port]>]
Command
clear dot1x config
show dot1x
Authenticator Only
1
enabled
2
60 seconds
3600 seconds
30 seconds
30 seconds
30 seconds
Command
show port dot1x help
Chapter 21 Configuring Switch Access Using AAA
78-13315-02