Configuring Rsvp Support - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring QoS
Enter the parameters as a number of seconds in the range 0 to 65535. The value of the initial parameter
plus the value of the increment parameter must not exceed the value of the maximum parameter.
This example shows how to configure the parameters COPS uses to communicate with the PDP server:
Console> (enable) set cops retry-interval 15 1 30
Connection retry intervals set.
Console> (enable)

Configuring RSVP Support

Note The commands in this section are not supported with a Layer 2 Switching Engine.
These sections describe configuring RSVP null service template and receiver proxy functionality
support:
•
•
•
•
•
•
•
•
Throughout this publication and all Catalyst 6000 family switch documents, the term "RSVP" refers
Note
to RSVP null service template and receiver proxy functionality support as implemented on the
Catalyst 6000 family switches.
Enabling RSVP Support
To enable RSVP support, perform this task in privileged mode:
Task
Step 1 Enable RSVP support on the switch.
Step 2 Verify the configuration.
Step 3
Display RSVP activity.
This example shows how to enable RSVP support:
Console> (enable) set qos rsvp enable
RSVP enabled on the switch.
Console> (enable)
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
41-66
Enabling RSVP Support, page 41-66
Disabling RSVP Support, page 41-67
Enabling Participation in the DSBM Election, page 41-67
Disabling Participation in the DSBM Election, page 41-67
Configuring Policy Decision Point Servers, page 41-68
Deleting PDP Server Configuration, page 41-68
Configuring RSVP Policy Timeout, page 41-69
Configuring RSVP Use of Local Policy, page 41-69
Chapter 41
Command
set qos rsvp {enable | disable}
show qos rsvp info
show qos rsvp flow-info
Configuring QoS
78-13315-02