Configuring Rgmp On The Msfc; Displaying Multicast Protocol Status - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Chapter 40 Configuring Multicast Services
Clearing RGMP Statistics
This command clears stored RGMP statistics.
To clear RGMP statistics, perform this task in privileged mode:
Task
Clear RGMP statistics.
This example shows how to clear RGMP statistics:
Console> (enable) clear rgmp statistics
RGMP statistics cleared.
Console> (enable)
RGMP-Related CLI Commands
The following RGMP-related CLI commands are accessible from the router:
Task
Enable or disable RGMP.
Enable or disable RGMP debugging.

Configuring RGMP on the MSFC

To configure RGMP on a VLAN interface on the MSFC, perform this task:
Task
Step 1 Access VLAN interface configuration mode.
Step 2 Enable RGMP.
You can use the debug ip rgmp command to monitor RGMP on the MSFC.

Displaying Multicast Protocol Status

This command displays the status (enabled or disabled) of the Layer 2 multicast protocols on the switch.
To display the multicast protocol status, perform this task in privileged mode:
Task
Display the multicast protocol status.
78-13315-02
Command
clear rgmp statistics
Command
ip rgmp
debug ip rgmp {group name | group address}
Command
Router(config)# interface vlan vlan_ID
Router(config-if)# ip rgmp
Command
show multicast protocols status
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Displaying Multicast Protocol Status
40-25