Cisco Catalyst 4500 E Supervisor Engine 6-E Series Installation And Configuration Note

Installation and Configuration Note for the
Catalyst 4500 E-Series Supervisor Engine 6-E
Revised: September 16, 2009
Product Numbers: WS-X45-Sup6-E
This publication describes how to install and verify the operation of the Catalyst 4500 E-series
Supervisor Engine 6-E. Refer to the software configuration guide for your switch for configuration
information for the supervisor engines and switching modules.
Catalyst 4500 E-series switching modules require the Catalyst 4500 Series Supervisor Engine 6-E,
Note
which requires Cisco IOS Release 12.2(40)SG or later.
Contents
This document contains these sections:
•
•
•
•
•
•
•
•
•
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2007 Cisco Systems, Inc. All rights reserved.
Safety Overview, page 2
Supervisor Engine 6-E, page 7
Port Cabling Specifications, page 11
Installing the Supervisor Engine, page 14
Attaching Module Interface Cables, page 17
Configuring Your Supervisor Engine, page 19
X2 Handling Guidelines and Installation, page 19
Related Documentation, page 29
Obtaining Documentation and Submitting a Service Request, page 29