Displaying Ip Multicast Information - Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual

Configuring CEF for PFC2
To enable IP MMLS on an MSFC interface, perform this task:
Task
Enable IP MMLS on an MSFC interface.
This example shows how to enable IP MMLS on an MSFC interface:
Router(config-if)# mls ip multicast
Router(config-if)#
Use the no keyword to disable IP MMLS on an MSFC interface.

Displaying IP Multicast Information

These sections describe how to display IP multicast information:
•
•
Displaying IP Multicast Information on the MSFC2
These sections describe displaying IP multicast information on the MSFC2:
•
•
•
•
•
Displaying IP MMLS Interface Information
The show ip pim interface count command displays the IP MMLS enable state on MSFC IP PIM
interfaces and the number of packets received and sent on the interface.
The show ip interface command displays the IP MMLS enable state on an MSFC interface.
To display IP MMLS information for an IP PIM MSFC interface, perform one of these tasks:
Task
Display IP MMLS interface information.
Display the IP MMLS interface enable state. Router# show ip interface
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
13-16
Displaying IP Multicast Information on the MSFC2, page 13-16
Displaying IP Multicast Information on the Supervisor Engine, page 13-20
Displaying IP MMLS Interface Information, page 13-16
Displaying the IP Multicast Routing Table, page 13-17
Displaying IP Multicast Details, page 13-17
Using Debug Commands, page 13-19
Using Debug Commands on the SCP, page 13-19
Chapter 13
Command
Router(config-if)# [no] mls ip multicast
Command
Router# show ip pim interface [type number] count
Configuring CEF for PFC2
78-13315-02