Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 457

Chapter 21 Configuring Switch Access Using AAA
To display the values for all the parameters associated with the authenticator PAE and back-end
authenticator on a specific port on a specific module, perform this task in normal mode:
Task
Display the values for all configurable and current
state parameters associated with the authenticator
PAE and back-end authenticator on a specific port
on a specific module.
This example shows how to display the values for all the parameters associated with the authenticator
PAE and back-end authenticator on port 1 on module 4:
Console> (enable) show port dot1x 4/1
Port
----- ------------------- ---------- ------------------- -------------
4/1
Port
----- ------------- -----------------
4/1
To display the statistics for the different types of EAP frames transmitted and received by the
authenticator on a specific port on a specific module, perform this task in normal mode:
Task
Display the statistics for the different types of
EAP frames transmitted and received by the
authenticator on a specific port on a specific
module.
This example shows how to display the statistics for the different types of EAP frames transmitted and
received by the authenticator on port 1 on module 4:
Console> (enable) show port dot1x statistics 4/1
Port
-----
4/1
Port
-----
4/1
To display the global 802.1x parameters, perform this task in normal mode:
Task
Display the PAE capabilities, protocol version,
system-auth-control, and other global dot1x
parameters.
78-13315-02
Auth-State BEnd-State Port-Control
connecting finished
Multiple-Host Re-authentication
disabled enabled
Tx_Req/Id Tx_Req Tx_Total Rx_Start Rx_Logoff Rx_Resp/Id Rx_Resp
--------- ------ -------- -------- --------- ---------- -------
97 0 97
Rx_Invalid Rx_Len_Err Rx_Total Last_Rx_Frm_Ver Last_Rx_Frm_Src_Mac
---------- ---------- -------- --------------- -------------------
0 0
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Command
show port dot1x mod/port
auto
Command
show port dot1x statistics mod/port
0 0
0 0
Command
show dot1x
Configuring Authentication
Port-Status
unauthorized
0 0
00-00-00-00-00-00
21-47