Cisco WS-X6066-SLB-APC - Content Switching Module Software Manual page 239

Chapter 13 Configuring CEF for PFC2
(1.1.11.1, 224.1.1.1) Incoming interface: Vlan11, Packets switched: 62430
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan11
(1.1.11.3, 224.1.1.1) Incoming interface: Vlan11, Packets switched: 62430
Hardware switched outgoing interfaces: Vlan20 Vlan9
RFD-MFD installed: Vlan11
Total hardware switched installed: 6
Router#
This example shows how to display a summary of IP MMLS information on the MSFC:
Router# show mls ip multicast summary
7 MMLS entries using 560 bytes of memory
Number of partial hardware-switched flows:2
Number of complete hardware-switched flows:5
Router#
Using Debug Commands
Table 13-3
Table 13-3 IP MMLS Debug Commands
Command
[no] debug mls ip multicast group group_id group_mask Configures filtering that applies to all other multicast
[no] debug mls ip multicast events
[no] debug mls ip multicast errors
[no] debug mls ip multicast messages
[no] debug mls ip multicast all
[no] debug mdss error
[no] debug mdss events
[no] debug mdss all
1. MDSS = Multicast Distributed Switching Services
Using Debug Commands on the SCP
Table 13-4
SCP that runs over the Ethernet out-of-band channel (EOBC).
Table 13-4 SCP Debug Commands
Command
[no] debug scp async
[no] debug scp data
[no] debug scp errors
[no] debug scp packets
78-13315-02
describes IP MMLS-related debug troubleshooting commands.
describes the Serial Control Protocol (SCP)-related debug commands to troubleshoot the
Description
Displays trace for asynchronous data in and out of the SCP
system.
Shows packet data trace.
Displays errors and warnings in the SCP.
Displays packet data in and out of the SCP system.
Catalyst 6000 Family Software Configuration Guide—Releases 6.3 and 6.4
Description
debugging commands.
Displays IP MMLS events.
Turns on debug messages for multicast MLS-related errors.
Displays IP MMLS messages from/to the hardware switching
engine.
Turns on all IP MMLS messages.
1
Turns on MDSS error messages.
Turns on MDSS-related events.
Turns on all MDSS messages.
Configuring CEF for PFC2
13-19